Nine precautions for leather embossing machine and high frequency plastic heat sealing machine

What should we pay attention to when we use high-frequency plastic heat sealing machine and leather embossing machine?
(1) The use of leather embossing machine and high-frequency plastic heat sealing machine must be placed in an appropriate space, because the machine is extremely sensitive to moisture and dust.
(2) When using the leather embossing machine and high-frequency plastic heat sealing machine, they must be equipped with a good ground, that is, connected to the correct ground.
(3) Regularly check the leather embossing machine and high-frequency plastic heat sealing machine. If there is serious insulation damage, burn or rupture, the insulation must be replaced immediately. If you continue to work, sparks will be generated and the operation cannot be completed.
(4) If there is a frequent spark phenomenon, this phenomenon is caused when the upper and lower molds are in contact with each other, and it is generated when the high frequency output. If not checked and repaired in time, it will cause damage to mechanical parts and affect normal work.
(5) If the leather embossing machine and high-frequency plastic heat sealing machine are stopped for more than one hour during use, and then restarted, you need to wait 10-15 minutes to warm up with the vacuum tube, which will help protect the use of the vacuum tube Lifespan,.
(6) When the power of the leather embossing machine and high-frequency plastic heat sealing machine is turned on, the sound of the fan rotating will be heard (the sound of 4KW 5KW has been relatively weak), and vacuum heat treatment. If the fan fails, it must be repaired immediately, or the vacuum tube will be damaged, which will eventually affect the normal use of the machine.
(7) Pay attention to the use of materials, so that the finished product should not be water or dust as much as possible. The above objects are likely to cause sparks.
(8) The empty tube of the leather embossing machine and high-frequency plastic heat sealing machine will generate high heat, so in order not to affect the cooling of the vacuum tube, the heat of the machine next to it should not be placed, and it should not be placed in the equipment directly exposed to the sun.
(9) In operation, in order to avoid accidents, when high frequency output, remember not to touch the pole output (ie upper mold), multimeter, test instrument or other low voltage, low voltage instruments are no longer available and try to measure the pole output directly.
Therefore, the use of high-frequency series equipment must be observed frequently to avoid accidents or damage to the machine.

RFQ

Technical guide

Customer Q&A

Categories

Products

HW-750 PLA degradable cup lid bowl machine (YASKAWA Yaskawa s

HW-1300 HDPE plastic turnover tray thick film blister machine

HW-1000 small layout automatic PP lunch box vacuum thermoform

HW-1220 new Siemens PLC computer controlled automatic vacuum

HW-520 automatic positive and negative pressure thermoforming

HW-850 Automatic Positive and Negative Pressure Four-Station

HW-850 Automatic Positive and Negative Pressure Three-Station


Product Consultation

We provide one-stop service of design, materials, molds, machines, and after-sales.